currently with my setup I ran a 12.488 @ 113
Mods are:
K&N cold air
mac crank pulley
tb bypass
taylor OVC wires
jacobs coil
autolite 104s
mac headers and y
custom 3" catback with cutout
100 NX shot

the reason I only want to shave 4 or so tenths is becuase I dont want to install a roll cage.

 

oh, and I dont want to bump up to a 150 shot....yet.

 

!AC
!Spare tire/jack
!Back seat
Skinnies

What were your short times?

 

my 60fts??
there are anywhere from 2.1 - 1.97s with Et streets (bad traction and im taking it easy on my rear end)

 

I'd put a 160* in your car, the cooler it is, the better it runs. Have you thought about any suspension mods? Do a couple of those, and you could be running the time you want.

Benji

 

a few more suspension mods, and maybe some longtubes should get ya there....any weight reduction wouldn't hurt either

 

LCAs and Subframe connectors cant hurt thats for sure, and the loss of weight obviously wont hurt you. I dunno if you thought of gears? i dunno what shifter you have but that can make a difference like Stock vs. Pro 5.0

 

ignore me, your a manual...

 

I was thiking about doing lcas and subframe connectors. I still have the stock shifter and im not to sure about gears.

 

If you insist on being easier on your rear you're just gonna have to jet up .

Cut a good 60' and you're in the 11's.

 

Running that high of a MPH with the stock cam you probably dont want to do gears, you are gunna run out of RPM in 4th gear and have to hit 5th.

 

12 bolt/9" tell me how you are leaving in it now?If you could pull a 1.7X I think that would get you were you want to be. or swap the M6 for a A4 and not worroy about the rear. I am beating on my 10 bolt pretty hard with 1.605 60ft times.. man that fells so good with a 3.23 gear