Crank Hub Removal Tool, What tool do you use after the balancer comes off?

 

Shoebox covers the removal of the crank hub in his cam removal writeup. You have to scroll down at least 3/4 of the way to the bottom, just below the red link for “Optispark mounting diagram”. It includes details if the specifics required to avoid problem specific to the LT1.

4th Gen LT1 F-body Cam Removal

 

A 3 spoke wheel puller tool will get it off.....its getting it back on that takes either a home brew one or the exploding wallet Kent Moore removal/install tool # J 39046. Sometimes you can find them on ebay but not heap. I bought one about 20 years ago but it was only $40 then

Home brew would be using the correct size all thread rod, thrust bearing and a stack of flat washers and nut. I made one for a Ford motor I have.

do not use the center crank hub bolt to "pull" it on...you will strip out the crank. Don't beat it on with a hammer either