Hey, my SES light just came on, an i put the scanner on it, an its Code 29? Does anyone know what that one is? an how i should go of fixing it, thanks.

 

Don't know how to fix it but you can look it up at http://shbox.com/1/Dtcs.htm

 

99% of the time, its due to a blown fuse for the AIR pump. Replace the fuse. If it continues to blow, disconnect the harness connector from the AIR pump, and then put the new fuse in. The SES light will go out. Of course the AIR pump won't work, but there's not much impact except more emissions on a cold start.

 

Dumb question, but where is the fuse located?

 

No owners manual? Also on Shoebox's site - http://shbox.com/pdf/manuals.html

 

Yea, after asking that question, i just looked in the owners manual an that told me, tho, i did replace the fuse with the proper one, an well it blew twice already. So how do i go of removing the AIR pump? An once i do, will the SES light always be on an if so, how do i remove it so it wont come back again?

 

just unplug the pump and then put a fuse in it, youl'll be good to go

 

Hey thanks dave, tho if i wanted to physically take it out, hard job or not? worth it?

 

a 3 bolts holding the pump to the bracket, 3 bolts holding the bracket to the engine, some rubber hoses, a metal tube, then you need to cap the holes in the exhaust manifolds

worth it if you want the room/clean up the engine bay, otherwise, no

 

Thanks once again Dave. I plan on doing a header intstall in the future, i just do it then.

 

Where do i unplug it from?

 

There's a harness connector plugged into the side of the AIR pump. You unplug that connector.