|
||
Aftermarket fuel injection optionsdkeers 12-01-2004, 09:38 AM Is there an aftermarket fuel injection setup on the market that can control 16 injectors (on a v8)? Did anyone use aftermarket engine management on the Lt5 vettes (they are the only production car I can think of that used 16 injectors that were controlled seperately) If so, where can I find out about it? Thanks Dustin Boost It! 12-01-2004, 11:30 AM Is there an aftermarket fuel injection setup on the market that can control 16 injectors (on a v8)? Did anyone use aftermarket engine management on the Lt5 vettes (they are the only production car I can think of that used 16 injectors that were controlled seperately) If so, where can I find out about it? Thanks Dustin Ford GT (the supercar) uses 16 rskrause 12-01-2004, 01:25 PM The Electromotive TEC3 can control 16 injectors. Good source: www.kennedysdynotune.com Rich dkeers 12-01-2004, 02:05 PM The Electromotive TEC3 can control 16 injectors. Good source: www.kennedysdynotune.com Rich Thanks. As far as I can tell, the TEC3 can only control 8 injectors (or 8 pairs of injectors that would essentially act like 8) since it only has 8 injector drivers. I need something more like the LT5 had where the two injectors on a cylinder can operate independantly. For example, only one of them runs when the fuel demand is small and the second set comes on like "secondaries". This is for a somewhat exotic application. Ford GT (the supercar) uses 16 I didn't know that. Is there any good place to get the details of this car? It sounds awesome, but I haven't read much about it. Dustin dkeers 12-01-2004, 05:24 PM I just found this ecu from pectel: http://www.pectel.co.uk/sub_page.cfm/section/products/editID/16 Does anyone have any experience with it? Dustin Highlander 12-01-2004, 11:30 PM why not use a supefueler from carrolsupercharging??? it has 3 additionals that could help out. Boost It! 12-02-2004, 01:55 AM Thanks. As far as I can tell, the TEC3 can only control 8 injectors (or 8 pairs of injectors that would essentially act like 8) since it only has 8 injector drivers. I need something more like the LT5 had where the two injectors on a cylinder can operate independantly. For example, only one of them runs when the fuel demand is small and the second set comes on like "secondaries". This is for a somewhat exotic application. I didn't know that. Is there any good place to get the details of this car? It sounds awesome, but I haven't read much about it. Dustin we have a few at work. what do you want to know. typical blown 5.4 rear engine car with an ugly stereo and wanabe race chassis. ****ing hell of a car for $125k though. 1racerdude 12-02-2004, 04:55 AM Call Electromotive and talk to them they can make their unit control anything you want to control.Have run 12 with their set up,the engine and 4 more.That was before they had big enough injectors to cover the HP and boost,but today that isn't the case,There are injectors that will cover anything EFI.16x100lb's will flow a ton of fuel.Got Pumps????? ASRoff 12-05-2004, 12:15 PM Big stuff 3 will handle 16 injectors. www.bigstuff3.com It offers more features and costs less than F.A.S.T and Accel DFI Tweaked Zed 12-08-2004, 12:49 AM I think FAST has an option to add extras too. | ||