I recently got water in my engine and it tore my heads all to hell. I went to have my heads pressured checked at the only place in town. And without asking me they re-manufactured them completely. 450$ right there. So being that far in the hole i decided to just go all out on the engine. New water pump, New Power Steering pump, new thermostat. New wireset, new sparkplugs, ALL new gaskets, New 02 sensor, New ignition control module. New Oil Filter, All fluids drained and replaced. So after that long story, i finally got the engine rebuilt and ready to go. I went to go start it and it cranked over but wouldnt start. The distributer is electronic so i can't set the cap. The sparkplugs are getting juice. The engine is getting air. But it doesnt seem like it is getting fuel. Possibly the computer needs to be reset? Can anyone help or offer any ideas? Im almost sure everything was put back in correctly. But then again im only 17 so mistakes are possible