V6 Mustang will kill a Z28, but not a Mach 1
Originally Posted by Bob Cosby
Here is a little article that talks about 2 cars (the LS1s at the top of the article) that should surely be labeled "factory freaks":


Did anybody notice that the SS in the picture appears to have a different set of wheels on the back? They appear to be old-style SS/ZR1 wheels, they definitely are not the same as the fronts, as the finish is different.
I'd bet that car was on a DR, especially since it went 12.9 on only 107mph.
Whaddya' think, Bob?
S.
Re: V6 Mustang will kill a Z28, but not a Mach 1
Originally Posted by Bob Cosby
It is not rare - at all, which was the point. Also, MM&FF reports STD corrections vice SAE, which would bring that 320 down to ~313 RWHP.
It is my opinion that power output varies 2-3% (above and below) the average.
It is my opinion that power output varies 2-3% (above and below) the average.
lol... k. i missed the sarcasm.
i didn't know that they used std corrections, though.
Re: V6 Mustang will kill a Z28, but not a Mach 1
Originally Posted by Steve Y
No idea. But way better than the 2.24 that I pulled with street tires! 

i should hope so! next time you plan on going to sactown, lemme know and we will run 'em.
Originally Posted by Bob Cosby
Don't think so, Sean. Evan probably had the starting so sticky that it would have hooked with snow on the ground. 

S.
Re: V6 Mustang will kill a Z28, but not a Mach 1
Originally Posted by jthomas
i should hope so! next time you plan on going to sactown, lemme know and we will run 'em.
You will probably spank me, though. I may go this winter and try to get some good times.
Re: V6 Mustang will kill a Z28, but not a Mach 1
SteveY - anyone with half a clue is sitting back laughing at you.
You don't have 1/10 of my knowledge. How many cam swaps have you done? Head swaps? Rebuilds? You have no experience...it shows. You seem to have fun pretending, so carry on. You're just a ricer with a slow *** Mustang.
Have a day.
You don't have 1/10 of my knowledge. How many cam swaps have you done? Head swaps? Rebuilds? You have no experience...it shows. You seem to have fun pretending, so carry on. You're just a ricer with a slow *** Mustang.
Have a day.
Re: V6 Mustang will kill a Z28, but not a Mach 1
I was at a party about 3 months ago and had a kid with a newr ford ranger with a 4 banger telling me his little fake truck would destroy my z...and he was totally serious. We were both a bit under the influence so I assume that may have had something to do with his absurd claim.
Facts are facts. Who cares what company you like more. A fox body 5.0 will beat a TPI Z anyday stock for stock, and just the same an LT1 or LS1 will beat any 4.6-5.0 gt, and most n/a cobra's stock for stck anyday. The fact remains though that blown cobras are still beating the pants off of Z06's and cost 20k less
Facts are facts. Who cares what company you like more. A fox body 5.0 will beat a TPI Z anyday stock for stock, and just the same an LT1 or LS1 will beat any 4.6-5.0 gt, and most n/a cobra's stock for stck anyday. The fact remains though that blown cobras are still beating the pants off of Z06's and cost 20k less
Originally Posted by Bob Cosby
I own a blown Cobra (2004). It's a fast car, but in stock trim, the Z06 is significantly quicker.
But don't tell that to the '03 Z06 owner on Monday that couldn't get past my bumper until I let off in 3rd gear from a dead stop at a light.
I contend that the difference is small enough that a well driven '03/'04 will fend off a moderately or poorly driven Z06.
There's more to my story...but another time, another place.
S.
Re: V6 Mustang will kill a Z28, but not a Mach 1
Yeah, you reach a point where, unless you have other mitigating factors such as AWD or a killer traction control (Mercedes), any two cars within a few ticks of each other boil down to driver. If you're talking 15-16 second cars, they're so slow that I don't think the driver matters much.
Is it possible to screw up the launch on a 16 second car so that it runs a 17?
Is it possible to screw up the launch on a 16 second car so that it runs a 17?
Re: V6 Mustang will kill a Z28, but not a Mach 1
Originally Posted by 97bowtie
SteveY - anyone with half a clue is sitting back laughing at you.
You don't have 1/10 of my knowledge. How many cam swaps have you done? Head swaps? Rebuilds? You have no experience...it shows. You seem to have fun pretending, so carry on. You're just a ricer with a slow *** Mustang.
Have a day.
You don't have 1/10 of my knowledge. How many cam swaps have you done? Head swaps? Rebuilds? You have no experience...it shows. You seem to have fun pretending, so carry on. You're just a ricer with a slow *** Mustang.
Have a day.
Yep, i'm a ricer even though I have only speed mods and NO appearance mods. You really have me figured out.
D!ckhead.
Last edited by Steve Y; Aug 25, 2004 at 07:42 PM.


