ES Rear Torque Arm Mount
Thread Starter
Registered User
Joined: Oct 2004
Posts: 833
From: La Porte, IN
ES Rear Torque Arm Mount
Does anyone know how to replace the Rear Torque Arm Bushing from the clamshell at the tail section of the transmission on an LT1? Please any help will be appreciated
Last edited by 19z28camaro02; Feb 22, 2006 at 07:41 PM.
Administrator
Joined: Nov 1998
Posts: 71,098
From: Hell was full so they sent me to NJ
Registered User
Joined: Feb 2006
Posts: 928
From: King of Prussia, PA
Re: ES Rear Torque Arm Mount
i dug this up from a while ago using the search (arent you proud of me?) and i was wondering what method of jacking everyone uses for this... do i just jack up the front and put it on jack stands? or should i jack up the rear? this is all i need to know and then i can do it
Administrator
Joined: Nov 1998
Posts: 71,098
From: Hell was full so they sent me to NJ
Re: ES Rear Torque Arm Mount
You can jack either end or both.... how high depends how comfortable you want to be crawling under the car. No matter which end you jack, you need to use jack stands before you get under the car.
Registered User
Joined: Feb 2006
Posts: 928
From: King of Prussia, PA
Re: ES Rear Torque Arm Mount
so if i were to jack the front and put it on jack stands.. after i take off the bushing is it going to be difficult to get the torque arm back where it needs to be with the rear sitting on the ground?
Thread
Thread Starter
Forum
Replies
Last Post
