Joe Overton cam
#1
Joe Overton cam
I have a cam that I got from Joe that is setup for a LT1 383 with 12.1 comp It is 240/248@50 with around 550 lift with 1.5RR It has less than 300 miles on it and looks new. I am going to a solid roller. I will take 200.00 firm or a will just keep it. I paid 400 for. Pm me if you are interested
#3
#5
Re: Joe Overton cam
I made 380rwhp through a TH400 with a 3800 stall converter with a 11.20 afr and letting out at 5700rpm due to a new motor I did not want to push it. The cam should of peaked at 6500rpm or a little more. This is all with a 383 motor The cam is made for a vented opti. But can be cut down for a nonvented opti
With my 383 I had 13in of vacuum. If that tells you how streetable it may be? It is a very lopy Idel thgough. It did drive good before I ended up having problems somewhere else though.
The DCR WAS 8.0 WITH MY MOTOR AND A 12.1 CR. So I would check what it would be on your motor other wise this cam would make your car a slouch if it is too much lower. In other words you will need around 12.1 comp to make this cam happy.
With my 383 I had 13in of vacuum. If that tells you how streetable it may be? It is a very lopy Idel thgough. It did drive good before I ended up having problems somewhere else though.
The DCR WAS 8.0 WITH MY MOTOR AND A 12.1 CR. So I would check what it would be on your motor other wise this cam would make your car a slouch if it is too much lower. In other words you will need around 12.1 comp to make this cam happy.
Last edited by cliff929; 04-23-2005 at 05:42 PM.
#6
Re: Joe Overton cam
Cliff,
This is Mike, Just talked to you over phone. Just wanted to let ya know who you was talking too. Talked to Glenn, Send him the specs and a shipping quote. Think he want the cam.
Later,
Mike
This is Mike, Just talked to you over phone. Just wanted to let ya know who you was talking too. Talked to Glenn, Send him the specs and a shipping quote. Think he want the cam.
Later,
Mike
Thread
Thread Starter
Forum
Replies
Last Post
Black Sunshine/ 00SS
Midwest
9
07-28-2002 10:21 PM