Jet Hot longtubes and custom y-pipe
01-26-2006, 01:52 PM
#1
Registered User
Thread Starter
Join Date: Aug 1999
Location: Where St. Augustine won't grow
Posts: 449
Jet Hot longtubes and custom y-pipe
Headers have been used for only 100 miles. Overall, they are in very good shape. They have some minor scuff marks from being installed and removed, and there are some oil stains on the passenger side header. The headers do not have emissions fittings, but do have O2 bungs.
The y-pipe is a custom 3-inch piece with about 15,000 miles on it. It's was section together using pieces of mandrel-bent U-bends. Since I hate leak-prone three-bolt flanges, I cut them off of the headers and welded them directly to the y-pipe. Obviously, I had to cut part of the y-pipe to get them off, but you could easily attach the assembly together again with band clamps, or just weld it back. Ground clearance is excellent with this setup.
I'll include a set of ARP 12-point header bolts and some O2 extensions.
$500 plus shipping obo
Pics:
http://community.webshots.com/user/v8beast
The y-pipe is a custom 3-inch piece with about 15,000 miles on it. It's was section together using pieces of mandrel-bent U-bends. Since I hate leak-prone three-bolt flanges, I cut them off of the headers and welded them directly to the y-pipe. Obviously, I had to cut part of the y-pipe to get them off, but you could easily attach the assembly together again with band clamps, or just weld it back. Ground clearance is excellent with this setup.
I'll include a set of ARP 12-point header bolts and some O2 extensions.
$500 plus shipping obo
Pics:
http://community.webshots.com/user/v8beast
Thread
Thread Starter
Forum
Replies
Last Post
ferraricameron
Drag Racing Technique
10
07-29-2002 07:46 PM