How did you guys route your purge?
#3
Re: How did you guys route your purge?
A little hard to see the solenoid and my application is with the Zex NMU but here's the pics from link:
http://i12.tinypic.com/4d470px.jpg
http://i12.tinypic.com/2hrzrdy.jpg
http://i12.tinypic.com/2dkag5i.jpg
The solenoid is attached to the hood support strut bracket. I didn't even have to drill a hole as there was one of the right size in the bracket already. I just used a kit screw with loctite and was good.
http://i12.tinypic.com/4d470px.jpg
http://i12.tinypic.com/2hrzrdy.jpg
http://i12.tinypic.com/2dkag5i.jpg
The solenoid is attached to the hood support strut bracket. I didn't even have to drill a hole as there was one of the right size in the bracket already. I just used a kit screw with loctite and was good.
Last edited by 01Z; 10-04-2006 at 08:53 AM.
#5
Re: How did you guys route your purge?
Where are your solenoids and where do you want it to purge to?
http://www.injuneer.com/images/photo.../DCP04344a.jpg
http://www.injuneer.com/images/photo.../DCP04344a.jpg
#6
Re: How did you guys route your purge?
I originally had mine mounted through the wiper cowl area as well, I removed it from there and I am going to route it to direct underneath the car to keep it out of view. Once I get the SS hood, I may try something creative, but I don't know yet.
#8
Re: How did you guys route your purge?
Originally Posted by Injuneer
Where are your solenoids and where do you want it to purge to?
http://www.injuneer.com/images/photo.../DCP04344a.jpg
http://www.injuneer.com/images/photo.../DCP04344a.jpg
have one selonoid on either side of the manifold just behind the throttle body....I guess I was planning on running the purge up and out at the bottom of the windshield around the wipers somewhere....tends to be the way I see most people do it.
Thread
Thread Starter
Forum
Replies
Last Post
Sergio
LT1 Based Engine Tech
11
01-27-2016 04:27 PM