Opti optical sensor feeding MoTeC M48Pro engine management system, MoTeC IEX 8-channel ignition driver running 8 LS1-style coils. You could do the same thing with the Bailey Engineering LTCC.

 

I got the sumit ones
Had the MSD....kept burning number 7

 

I ran the Accel 9000 race wire...loved them

 

Taylor OTVC. They were over the top for a few weeks but when the car went into the shop to swap the shorties for longtubes they decided to run them in the stock locations. Oh well.

 

MSD's factory route

 

HOLY COW THERE'S DIRT ON THE UNDERSIDE!

 

Will 8mm wires fit behind the acc bracket?



David

 

The 8.5 MSDs were a tight fit for me. They did clear the bracket though.

I ended up cuting a wire when a serpentine belt jumped off due to the wierd routing. Take care to secure the wires. The tight fit left one or two wires sticking out a bit right near my AC bracket.

 

Taylor's factory route with pasesetter LT's

 

Crane firewire FWIW.

 

Accel 8.8 300+ Race Wire.. Can't complain, works great with my Delteq setup!

 

Granatelli wires in stock location. 0, that's zero ohms of resistance. Hooker headers (they're the worst) Get everything I can from Summit. I think they were 160.

Got some MSD wires you can buy cheap from me. Never used

 

Magnacore: roughly $100 custom length for LTCC
TPIS LT's

 

WHat color, size, what boots, cut to fit or pre-made.


David

 

They are cut to fit. Correct boots for opti and plug ends. Like stock. Coil wire is too long. Just looped and wire tied it. They are Blue.

See them here.
http://www.granatellimotorsports.com...kplugwires.htm

Funny but I thought the "0" ohms would get someones attention.

Since they provide so much energy, you can (they even come with instructions) to open the gap a little more for improved performance.