OVC wires and ASR "box"?

Reply Subscribe

Thread Tools

Search this Thread

Mar 16, 2003 | 12:37 AM

mtealz

Thread Starter

Registered User

Joined: Jun 2002

Posts: 38

From: Southlake, Texas, USA

How do I run OVC wires with ASR on Drivers side

I am going to install some Hooker LTs in a bit and was wondering how to route the wires with that damn ASR box on the drivers valve cover? I'll probably get the Taylor kit from Thunder. I was just wondering if anyone else has Hooker LTs and Tractrion Control (and no I cant remove it right now) and how they routed the wires.(pics if possible)
Thanks
Wade

Last edited by mtealz; Mar 16, 2003 at 02:56 AM.

Mar 16, 2003 | 01:11 AM

mtealz

Thread Starter

Registered User

Joined: Jun 2002

Posts: 38

From: Southlake, Texas, USA

ttt

Mar 16, 2003 | 03:50 AM

mtealz

Thread Starter

Registered User

Joined: Jun 2002

Posts: 38

From: Southlake, Texas, USA

ttt

Mar 17, 2003 | 11:40 PM

mtealz

Thread Starter

Registered User

Joined: Jun 2002

Posts: 38

From: Southlake, Texas, USA

anyone have OVC wires and ASR?

Mar 17, 2003 | 11:57 PM

97CamaroZ28R

Registered User

Joined: Sep 2002

Posts: 88

From: dallas, tx area

I have Taylor OVC Wires and ASR. To install the OVC Wires you have to loosen the ASR bracket from the intake manifold, then you will have the clearance to insall wires and looms.

I just took some pictures of my wires installed, I will e-mail you.

Mar 18, 2003 | 12:06 AM

mtealz

Thread Starter

Registered User

Joined: Jun 2002

Posts: 38

From: Southlake, Texas, USA

Thanks a lot. Apparently were the only ones with ASR and OVC wires.j/k

Thanks again
Wade

Apr 18, 2003 | 03:23 PM

trax

Registered User

Joined: May 2002

Posts: 611

From: Chicago 'burbs

Looks like 3 of us

I'm going home tonight to finish up the motor and it just hit me that this might cause me some problems... but I don't have the typical Taylor looms. We'll see how it goes.