hell I will buy it.

PM me

 

Mike are you upgrading?


David

 

Yeah I want too.

 

Your setup would run goooood with that breather on it, Het go to MMCT I tryin to set you up with a 10 sec (LMAO) EVO from Pcola.


David

 

SO where is the intake now?. Whast the status?

 

Hahaha I held my breath and about passed-out

 

The status? Resting nicely in the garage. Do to some extra exspenses and delays, posi, fuel pump, touch up the tune, family vacation, there has been a slight set back. OK a big setback! Plus some better weather would be nice for some final track times (next month) with the current set-up. I'm trying to have some honest baselines before the manifold goes on. So take another breath, it might not be until spring.

 

You need to move down south. Its damn near 95 degrees out here.

 

So what ever happened to this intake? I just read through atleast 20 some pages of posts about this, and now it just dropped off. Wheres the intake and what happened????

 

Ken sold it to a guy and I haven't heard anything about it.... costs to make the thing were too high compared to single plane intakes.

Bret

 

I pm'd the guy not to long ago and he ran into some problems w/ his fuel pump & posi. These damn cars are expensive!!

-b

 

That intake is very cool.

 

Aww man...I thought there was an update on track times with the intake or soemthing. but yes it is a cool intake.

 

Good to hear it's still out there....

Probably have lots of numbers on the bolt single planes before this puppy gets running.

Bret

 

[QUOTE=SStrokerAce]Good to hear it's still out there....

Probably have lots of numbers on the bolt single planes before this puppy gets running.

Easy there Bret, it'll get done sooner or later. Did you ever get any before and after #'s with the other two Pro Rams you mentioned you were building? And if you don't mind me asking, are we sure this manifold will fit under my stock hood? I haven't done any measureing, but it looks like it might be a close fit at the front. I'm not against buying an aftermarket hood, but I'm trying to keep the stealth look and costs down if possible.