I just did a motor swap and cant find the wire that plugs into the temp sensor on the drivers side head.

Their is also a pigtail with 2 wires on it near the back bottom of the drivers side wheel well. But if that is the wire it wont reach the sensor.

 

make sure you didnt mix up an ABS plug

 

On my 93, the wire has a bluish connector and its in a
harness that comes from the back of the motor to'
the front along the drivers side intake. It wraps down
in front of the coil/ignition module and comes from
under #1 header tube to connect to the sensor.

93Z,383,Vortech,NOS,water/methanol

 

I found this pic on Shoebox's site. It should help. http://shbox.com/1/harness.htm

 

tnx alot guys, i am sure i can find it now.

I think i mistuck it for the air pump power supply and just zip tied it out of the way.