Got the car dyno'd yesterday
#1
Got the car dyno'd yesterday
Well I made the 40 min drive to speedtec and get the beater dyno'd. It didn't turn out to bad for an Auto. The car was running rich like 12.4 up until 5000rpm then there was some type of miss fire or some thing and it went to 11.9 and the graph whent jumping all around. Let me know what you think.
Any ways here they are.
284 hp & 307 tq
280 hp & 309 tq
279 hp & 305 tq
Thanks
Mods
96ta A4 3.23
Hooker lt's
Really crapy home made Y pipe no cats
Flomaster cat back
csi water pump
fipk
Any ways here they are.
284 hp & 307 tq
280 hp & 309 tq
279 hp & 305 tq
Thanks
Mods
96ta A4 3.23
Hooker lt's
Really crapy home made Y pipe no cats
Flomaster cat back
csi water pump
fipk
#3
good dyno
mine i have m6 97 dynoed 291 321 ponds torque 2920 full weight
stock borla cat back 52mm tb pullies and hpp now lt1 edit long tubes 310 340 so thats good for auto . get pullies and tb and cai
then go to speedworks and let them tune it...
stock borla cat back 52mm tb pullies and hpp now lt1 edit long tubes 310 340 so thats good for auto . get pullies and tb and cai
then go to speedworks and let them tune it...
#5
yes it is at the wheels.
I am really curious what it would put down if I had it tuned, fixed the miss and thru on a cut out and the 1.6RR I have sitting in my house.
But these are just going to be my base #'s before I pull the heads to have them ported some time this month.
I am really curious what it would put down if I had it tuned, fixed the miss and thru on a cut out and the 1.6RR I have sitting in my house.
But these are just going to be my base #'s before I pull the heads to have them ported some time this month.
#6
Originally posted by BeaversTA
yes it is at the wheels.
I am really curious what it would put down if I had it tuned, fixed the miss and thru on a cut out and the 1.6RR I have sitting in my house.
But these are just going to be my base #'s before I pull the heads to have them ported some time this month.
yes it is at the wheels.
I am really curious what it would put down if I had it tuned, fixed the miss and thru on a cut out and the 1.6RR I have sitting in my house.
But these are just going to be my base #'s before I pull the heads to have them ported some time this month.
Thread
Thread Starter
Forum
Replies
Last Post