code 34 - map flatline on datamaster
#1
code 34 - map flatline on datamaster
Datamaster shows code 34 - the map sensor is flat lined at 10.6 kpa (I mean no change at all under any throttle or load condition)
So I replaced the pigtail and am reasonably confident that I crimped it in correctly, but still no change, sensor remains at 10.6
I to get about 4.8 volts at the unplugged pigtail when jumping green and black, key on engine off.
Map is clear of oil, orange seal seems fine
Question:
How do I check voltage with my multimeter while the pigtail is plugged into the sensor?
What else should I check before buying a new map?
thanks
So I replaced the pigtail and am reasonably confident that I crimped it in correctly, but still no change, sensor remains at 10.6
I to get about 4.8 volts at the unplugged pigtail when jumping green and black, key on engine off.
Map is clear of oil, orange seal seems fine
Question:
How do I check voltage with my multimeter while the pigtail is plugged into the sensor?
What else should I check before buying a new map?
thanks
Thread
Thread Starter
Forum
Replies
Last Post