Canton pan resting on K-member causing false knock?
Thread Starter
Registered User
Joined: Jul 1999
Posts: 3,647
From: Winnipeg, Manitoba, Canada
Canton pan resting on K-member causing false knock?
I have an aftermarket K-member and the Canton pan rests on the power steering and K-member. My headers also touch the K-member.
Could this cause false knock? Any idea on how to get rid of it?
Could this cause false knock? Any idea on how to get rid of it?
Registered User
Joined: Jun 2003
Posts: 1,439
From: New Jersey
Re: Canton pan resting on K-member causing false knock?
to my knowledge any strong vibration, espeically header vibrations can cause false knock. I think some have reported that they have had the same issues with exhausts causing false knock, some even said solid motor mounts sometimes do also, but not many have chimed in with that. But that could def be an issue....
Banned
Joined: May 2003
Posts: 6,661
From: LA (lower Alabama)
Re: Canton pan resting on K-member causing false knock?
ANY noise will pull timing.
Get 6 thick torque flat washers(3 to the side under each bolt) and put them between the block and motor mount.It will bring the engine up about 1/8".
Get 6 thick torque flat washers(3 to the side under each bolt) and put them between the block and motor mount.It will bring the engine up about 1/8".
Thread
Thread Starter
Forum
Replies
Last Post
