I did the cooling fan mod yesterday in about 30 min. My switch now operates the fans at low speed. The only thing is, the instructions I was using showed how to operate the fans at high speed as well, but it would throw a code. Does any one know how to wire it to operate bothe fans at high speed w/o throwing a code? How long does the battery last like this by the way? Thanks alot



Bad Andy

 

I've seen a way to do that, but I'll have to dig through and find it. I do remember that the wiring was done at the connector on the passenger side of the top of the wheel well under the hood.

 

did u buyt the slp fan switch or did u make your own...???

 

I made my own. Piece of cake. Didn't even cut the harness. But I want to use both fans at high speed. I know that I can jumper relay 1 and two to run them in series, which runs them at high speed, but this throws a code. Help!