build my bottom end for 800rwhp

Reply Subscribe

Thread Tools

Search this Thread

Mar 9, 2005 | 09:38 AM

#16

turbo camaro

Registered User

Joined: Mar 2005

Posts: 1

Re: build my bottom end for 800rwhp

Quote:

Originally Posted by LT1RX7

Time to start building my car for this race season. Been getting alot of suggestions on how I should build my bottom end so I just wanted to hear what you guys think I should buy.

To make things simple, I was thinking of getting these

http://cgi.ebay.com/ebaymotors/ws/eB...category=46098

and these

http://cgi.ebay.com/ebaymotors/ws/eB...category=33620

Probably would change the rods to Eagle H-beams

Do you think this kit will handle what I'm looking for? I mean, I'm not looking for too much. It's only going to see 2K miles a year tops. Going to run a T88, stock ported heads w/ 2.02/1.60 valves.

What do you think guys? Should I think more expensive or should these do?

whats up man will tell me tell you a little about me i run a twin turbo 80 camaro.friends off are doc.z twin turbo 70 camaro best time to date 7.90 gm block eagle crankshaft eagle h beam rods trw pistons.red nove seen in hot rod pump gas drags eagle crank eagle rods dart little m block.best time to date 8.9 pump gas at 18 pounds.found a real good place to get parts .cmc motorsports i get most of my stuf in less then a week.i just got a eagle crank from then 4340-nontwist forged steal for $488.as for the block if it is a 2 bolt block you can go with splade caps but you will run into water drilling the hole so you will have to seal the outer bolt's.if its a 4 bolt block go with the billet caps all 5.you will have to have the motor line honed so let the shop also do the balance gob.