Street Twin installed = Holy crap!! Got some ??
Thread Starter
Registered User
Joined: Sep 2001
Posts: 175
From: Massachusetts
Re: Street Twin installed = Holy crap!! Got some ??
I have a carbon fiber driveshaft, so I think I'm petty good as far as the driveshaft is concerned. But, I do not expect my poor old 10-bolt to last that long, no hard launches or mad power shifting until I can replace the stock rearend. I'm saving for a strange 12-bolt or a Fab 9" from Billingsly Racing, that should take care of my weak rearend.
Everyone... Thanks for all the help, support and suggestions!
Everyone... Thanks for all the help, support and suggestions!
Registered User
Joined: Apr 2001
Posts: 2,195
From: Springfield, IL
Re: Street Twin installed = Holy crap!! Got some ??
Originally Posted by roguedriver
Their grabby, but it will loosen up a bit. I wasn't expecting that when I got mine off jackstands, then proceeded to let the clutch pedel and immediatly backed the car into the garage door jam crunching my quarter panel. So my street twin cost about $1500 instead of $1000.
Ken R.
Ken R.
that sucks but it had me laughing 
Registered User
Joined: Jun 2000
Posts: 1,542
From: Long Island, NY ; Norfolk, VA
Re: Street Twin installed = Holy crap!! Got some ??
FWIW the spline in the yoke is what's going to twist.. not the shaft itself.. and personally i wouldn't want a composite driveshaft either in a drag application either.. when you get your upgraded rear i would def. look into either a denny's or a Spohn d.s both meatier unit's.. Good luck w/ your new clutch.. you have just gotten the last one you'll ever need 
only 325 to rebuild it as well.. 
only 325 to rebuild it as well..
Registered User
Joined: Jul 2003
Posts: 1,668
From: Cliffside Park, NJ
Re: Street Twin installed = Holy crap!! Got some ??
Originally Posted by IllusionalTA
FWIW the spline in the yoke is what's going to twist.. not the shaft itself.. and personally i wouldn't want a composite driveshaft either in a drag application either.. when you get your upgraded rear i would def. look into either a denny's or a Spohn d.s both meatier unit's.. Good luck w/ your new clutch.. you have just gotten the last one you'll ever need only 325 to rebuild it as well..
only 325 to rebuild it as well.. Does breaking tranny/ds/and rear happen from shifting hard once you get to a rolling start? Well, i'm sure it does... but how likely is that to happen?
Thread
Thread Starter
Forum
Replies
Last Post
