Well, i finally ordered the street twin.
I was wondering if there is anyway i can test my Slave cylinder to make sure its still working like it should.
Also where can i get JUST the Slave. Thanks



Also, how do i go about bleeding evertyhing after i put the Mcleod master cylinder.

Thanks
Marcin

 

I don't think its possible to get just the slave. I'm pretty sure GM only sells the whole hydraulic assembly. Install University has a writeup on the McLeod master cylinder install HERE. Granted its for an LS1, but it has a procedure for bench bleeding which should be the same for both LS1s and LT1s. After bench bleeding, I assume you just bleed it on the car like your normally would. Let us know how the install goes.

 

it has to be possible as few people on the board got some...but non of em say where from!

 

I got just the slave from a local parts store, I think it was around 70-80$ bucks? I saw no reason to buy the whole damn thing from GM since I got the awsome adjustable one with the kit.

 

Maybe try Murray's or AutoZone. Just call em up on the phone...

 

is there a way to test the slave to make sure its working fine?