My 2nd and 4th gear band is constantly breaking and i'm getting teaked by it. I have already chaged my Transimission and stills break. What could the problem be

 

where does it break? what brand band is it, is it always the same kind? its probly your shift kits fault, i know one guy on here talks about shift kits taking out the band and the 3-4 clutches.

 

Who's 2/4 servo are you running and I think you have the pin adjustment on it set to "tight".

Ellis, you out there??? answer this post bro

 

The breakage is usually (1) Too big of a 2nd gear feed hole in the valve body plate. (2) No or little accumulation. (3) Too much line pressure at light throttle openings. (4) Too large of an apply servo. I have never had a band break when everything is matched (feed hole size in the valve body plate, accumulation, apply servo, etc.). If I can be of help let me know? The Trans-Go Performance Shift kit will not harm the 2-4 band if installed correctly. Just don't add more than one washer in the 2nd gear accumulator, not necessary.