length for A3 driveshaft
Administrator
Joined: Nov 1998
Posts: 71,097
From: Hell was full so they sent me to NJ
Don't know how the length compares on the TH350 vs. TH400, but I have a driveshaft for sale. Mark Williams #39800 3" chrome moly, with #39004 TH400 yoke, solid 1350 Spicers. It was used briefly with my TH400/Strange 12-bolt setup. I replaced it only because I needed a much shorter shaft when I added the Gear Vendor, and a buddy of mine had a spare avaiable. If you are interested, e-mail me. I can tell you the length.
This DS cost over $600 with shipping. Sell for $450 firm + shipping. Buyer responsible for verifying required length.
------------------
Fred
94 Formula A3+1: 381/TH400+OD/N2O
Advanced Tech Posting Guidelines
Detailed Mod's List
11.513@115.59 on motor; 11.162@127.67, 1.643 60' on a 125-shot. Going with a 275-shot this year
[This message has been edited by Injuneer 94FormM6 (edited September 09, 2002).]
This DS cost over $600 with shipping. Sell for $450 firm + shipping. Buyer responsible for verifying required length.
------------------
Fred
94 Formula A3+1: 381/TH400+OD/N2O
Advanced Tech Posting Guidelines
Detailed Mod's List
11.513@115.59 on motor; 11.162@127.67, 1.643 60' on a 125-shot. Going with a 275-shot this year
[This message has been edited by Injuneer 94FormM6 (edited September 09, 2002).]
Thread
Thread Starter
Forum
Replies
Last Post