You have no clue about the Terminator block do you? The Cobra Block comes from the Factory with Forged Pistons and Manley Rods. People have already topped 1000 horsepower on the stock Shortblock.

If you'd like i could gladly link you to various dyno graphs and video's of Kenne Bell and Procharger Blown Cobra's at 19+ Psi on pump Gas.

 

stock z06 trapping 120, thats the funnies reply I have heard yet...

 

go search the z06 boards if you dont believe me. his name is Jrod. outstanding driver he is.

 

yeah, I did, maybe his z06 is one in a 1000....I have yet to see an average driver pull1.5 60 ft times...

 

um im sorry, refresh my memory here, where did i say he was an average driver?

 

Whys it hard to believe, the new cobras are forged iron blocks

 

Antz,

He's simply clueless about the Cobra. Pretty Typical these days

 

To many variables...

If you can't pull 11.5-11.7s on a tire with a h/c/+ all bolt ons LT1 @ around 115-117, than somethings wrong. I've seen too many cars with your set up make runs down the 1320 to say any different.

That said, assuming your car would have simular ET/MPH, a stock to MILDLY modded Cobra shouldn't be a problem (again a lot of variables). Worst case senerio, a lightly modded w/ good driver Cobra would be a good run.

A stock '02+ Z06 should be a good run depending on the variables, mainly the driver and whether or not its dig/roll, etc. You could walk all over him, it just depends.



Jon