Track Kill Stories Race Track Victories, 1/4 Mile Times, Dyno Numbers - DRIVE RESPONSIBLY

Finally some respectable times

Thread Tools
 
Search this Thread
 
Old 01-19-2009, 05:10 PM
  #16  
Registered User
 
Orr89rocz's Avatar
 
Join Date: Jul 2007
Location: Pittsburgh
Posts: 353
not bad, 12.95 at 103.8 is what i ran with a full bolt on L98 in a 89 Irocz. Thats right on line with you, i made close to if not alittle less power than an LT1 but my car was bit lighter.

Sounds like you got that car running really good for the mods
Orr89rocz is offline  
Old 01-19-2009, 05:47 PM
  #17  
Registered User
Thread Starter
 
LSWHO's Avatar
 
Join Date: Apr 2007
Location: Az
Posts: 927
Originally Posted by Orr89rocz
not bad, 12.95 at 103.8 is what i ran with a full bolt on L98 in a 89 Irocz. Thats right on line with you, i made close to if not alittle less power than an LT1 but my car was bit lighter.

Sounds like you got that car running really good for the mods
Well, I haven't run a 12.98 yet. But I still have a few bolt ons left to do!
LSWHO is offline  
Old 01-19-2009, 07:31 PM
  #18  
Registered User
 
Orr89rocz's Avatar
 
Join Date: Jul 2007
Location: Pittsburgh
Posts: 353
correcting to sealevel sorta counts, my run was at 188 ft DA which is as close to sealevel you can get
But if your running that quick with pretty much stock motor with cutout, you will REALLY pick up with headers/exhaust/CAI and new tune
Orr89rocz is offline  
Old 01-19-2009, 08:44 PM
  #19  
Registered User
 
Demon's Camaro's Avatar
 
Join Date: Dec 2005
Location: Syracuse NY
Posts: 234
Unless there was some grave error in typing he stated he has those on his car but then left out the LTs on the second post.

He has the tune, cai, cutout(makes exhaust obsolete) and I assume headers on too.
Demon's Camaro is offline  
Old 01-19-2009, 10:09 PM
  #20  
Registered User
 
Orr89rocz's Avatar
 
Join Date: Jul 2007
Location: Pittsburgh
Posts: 353
i dont know i took it as he had converter, tires, and cutout only.

i know a kid with a 95 Z28 with full ehxaust/longtubes, tune/CAI and he runs 12.90's at 105-106 with stock auto trans/3.42 gears on street tires (read NOT drag radials) so if he has those mods then its not quite as impressive

Its mph should be up with those mods, but with stock exhaust i can see it being alittle lower like 100-102.

Reread the thread... he ran low 13's at about 100 with stall,cutout and i see he has added LPP's and ORY and went to 103.8 mph.. thats abit better but still abit lower than what i'd expect. Then again it may be abit heavier car than my buddies 95. his car probly was around 3450-3500 plus his little 150lb *** My car felt lighter when we pushed them to the staging lanes, and my car weighs 3300 lbs

Last edited by Orr89rocz; 01-19-2009 at 10:13 PM.
Orr89rocz is offline  
Old 01-19-2009, 10:53 PM
  #21  
Registered User
Thread Starter
 
LSWHO's Avatar
 
Join Date: Apr 2007
Location: Az
Posts: 927
Originally Posted by Demon's Camaro
Unless there was some grave error in typing he stated he has those on his car but then left out the LTs on the second post.

He has the tune, cai, cutout(makes exhaust obsolete) and I assume headers on too.
The "second post" I believe you are talking about was in regards to my 13.4 run so I didn't have headers at that time.

The 13.1 run was with LPPs on. Sealevel corrected to 12.98.

This post was originally about a 13.4 run, then I updated with the new mod and the new time.

Oh and I'm 190lbs. and the car's pretty much full weight. I wouldn't expect a stalled auto to trap any more than 103 with the few mods I have.
LSWHO is offline  
Old 01-20-2009, 04:10 PM
  #22  
Registered User
 
Orr89rocz's Avatar
 
Join Date: Jul 2007
Location: Pittsburgh
Posts: 353
full weight and 190 lbs i can see 103-104 mph traps
Orr89rocz is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
10-31-2016 11:09 AM
Roadie
Parts For Sale
7
02-16-2015 10:34 AM
AlaskaZ28
LT1 Based Engine Tech
9
01-01-2015 12:30 PM
ChrisFrez
CamaroZ28.Com Podcast
2
12-07-2014 06:01 PM
GOATCRAZY
Automotive News / Industry / Future Vehicle Discussion
20
07-17-2002 06:06 PM



Quick Reply: Finally some respectable times



All times are GMT -5. The time now is 09:02 PM.