What torque arm will clear both a T56 and a th400?

There's a T56 now but there will be a TH400 later this/next year.

Should any chassis mount work or am I going to run into length issues?

Thanks

~Jim~

 

I used the same Spohn TA with both the T56 and the TH400, and a TH400 + Gear Vendor. Only time I had a problem was adding the GV O/D. Same torque arm, but the DS loop had to be moved back about 8". Since the front mount for the TA bolts to the "g-load" chassis brace pads, its hard to see how the length of the TA would be dependent on the tranny.

 

Any chassis on should work just fine, I run the UMI one. Its short and off the tranny