BMR Tubular K - How to line up A-Arms in slots?
#1
BMR Tubular K - How to line up A-Arms in slots?
IIRC, the stock K-member had holes, where-as this k-member has slots. What for? Is it part of the alignment? From what I can tell, all that it would affect is toe-in/out, and that can be done with tie-rod ends. I searched but I don't see anything about how to set this up right, nor on BMR's site.
Thanks!
Dave
http://paradox.shacknet.nu/dave88lx/...installed1.jpg
Thanks!
Dave
http://paradox.shacknet.nu/dave88lx/...installed1.jpg
Thread
Thread Starter
Forum
Replies
Last Post