MSD 8.5 Universal wires cut and crimped for OVC looms...
#1
MSD 8.5 wires already cut w/ Billet OVC looms.
Okay instead of selling only the wires, I will try to sell both the wires and the looms as a package. The looms are billet brushed aluminum w/ black plastic wire holders. Comes with all necessary hardware (stainless allen bolts, nylock nuts). These looms are VERY trick because they don't run over the valve cover, instead they bolt to the two middle valve cover bolts but the bracket where the wires latch on to runs down the side of the valve cover. That makes for less wire slack between the loom and plug and also makes the setup look a lot less cluttered and overall more clean.
Wires are MSD 8.5 cut for OVC wires routed with a little bit of slack just incase. They have been on for a total of TA DA - 3 whole starts!!! No road driving time on them. The entire setup is practicaly brand new. Only reason I'm selling is because I thought my problem was the loom when it was really my POS NGK spark plugs so I routed regular stock location wires and I am too lazy to switch back.
100 shipped priority mail so you can have it by friday! Email or PM me.
Wires are MSD 8.5 cut for OVC wires routed with a little bit of slack just incase. They have been on for a total of TA DA - 3 whole starts!!! No road driving time on them. The entire setup is practicaly brand new. Only reason I'm selling is because I thought my problem was the loom when it was really my POS NGK spark plugs so I routed regular stock location wires and I am too lazy to switch back.
100 shipped priority mail so you can have it by friday! Email or PM me.
Last edited by 96 WS6; 07-06-2004 at 07:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SMO Q
LT1 Based Engine Tech
2
02-11-2015 07:13 AM
Rich_z28
Car Audio and Electronics
3
08-29-2002 10:44 PM