lt1 Camaro, Firebird twin turbo hot pipes
02-22-2012, 03:18 AM
#1
Registered User
Thread Starter
Join Date: Dec 2011
Posts: 30
lt1 Camaro, Firebird twin turbo hot pipes
I have a twin turbo hot pipes for a 93 to 97 camaro or firebird. I ran these on my 94 camaro z28 with the lt1 engine for 2 years with no issues. and the flanges were bench ground to make sure it wasn't warped after welding.
the specs are
its made out of 16 gauge steel,
The hot pipes are made for a t4 turbo and a tial 44mm wastegate,
primary are 1.5",
log manifolds are 2.25 to turbo,
3" dump pipe straite to the ground. ( i had th mufflers come out of the front bumper on each side in front of the tires.)
you must put the radiator up vertical and put a ac delete pulley in. other than that it will work with a stock car. and some of the bolts where hard to start. but i got all the bolts to fit and sealed for 2 years
these are fully tig welded.
can be easly modified to make a nice single turbo kit
the specs are
its made out of 16 gauge steel,
The hot pipes are made for a t4 turbo and a tial 44mm wastegate,
primary are 1.5",
log manifolds are 2.25 to turbo,
3" dump pipe straite to the ground. ( i had th mufflers come out of the front bumper on each side in front of the tires.)
you must put the radiator up vertical and put a ac delete pulley in. other than that it will work with a stock car. and some of the bolts where hard to start. but i got all the bolts to fit and sealed for 2 years
these are fully tig welded.
can be easly modified to make a nice single turbo kit
02-22-2012, 03:07 PM
#5
Registered User
Thread Starter
Join Date: Dec 2011
Posts: 30
Re: lt1 Camaro, Firebird twin turbo hot pipes
i had vortec, procharger, rear mount, strocker NA, and a couple front mounts. the only reason im selling this is i put a manual rack in and i cant run these pipes with out modifying it. so i figured i would sell them and start from scratch. there about 20 to 25 hours to make then 3 to 4 to tig it. ( i dint tig these my old school did it in there welding course. pretty good chance it was me. did the guy you but it from have a red trans am or a purple perl camaro. and im the only one with a 4th gen with power around here
Last edited by tt383lt1; 02-22-2012 at 03:10 PM.
02-22-2012, 05:25 PM
#6
Registered User
Join Date: Feb 2012
Location: Minnesota
Posts: 235
Re: lt1 Camaro, Firebird twin turbo hot pipes
Ya man it was you, remember i had a green formula, i came with one other guy.
I never ended up putting that setup on my car, just ended up selling it to some guy in arizona later that year.
I moved about 2 hrs away now and Im rebuilding my motor now to make it a little faster.
You had some pretty good prices
I never ended up putting that setup on my car, just ended up selling it to some guy in arizona later that year.
I moved about 2 hrs away now and Im rebuilding my motor now to make it a little faster.
You had some pretty good prices
Thread
Thread Starter
Forum
Replies
Last Post