FS: 1-3/4" Hooker Long Tubes for LT1
FS: 1-3/4" Hooker Long Tubes for LT1
I have 1-3/4" Hooker LTs off my '94 LT1 for sale. They are Jet Hot coated with four O2 bungs (with caps for 2 of them). Pics :
http://www.afrashteh.com/pics/hookers
Some minor rust, moderate scratchs along with a very small dent (probably from K-member). This is the "original" design, so they don't kiss the under frame like the new ones. These headers go for over $700 new with coating and two O2 bungs. The additional bungs are there for wide band O2 tuning which came at added cost. These headers do NOT have provisions for AIR or EGR. They will make gains over 1-5/8" shorty headers along with much more mid-range torque. Plug access is good and plug wire routing is not difficult nor does it require heat shielding. They will fit on a '93-'97 f-body - a new y-pipe is mandatory.
Asking $450 + shipping from 22310. I've made multiple sales on this board, do a search if you like.
If you have questions, EMAIL ME at aa4d@erols.com as I will rarely look at this thread!
-Alex
http://www.afrashteh.com/pics/hookers
Some minor rust, moderate scratchs along with a very small dent (probably from K-member). This is the "original" design, so they don't kiss the under frame like the new ones. These headers go for over $700 new with coating and two O2 bungs. The additional bungs are there for wide band O2 tuning which came at added cost. These headers do NOT have provisions for AIR or EGR. They will make gains over 1-5/8" shorty headers along with much more mid-range torque. Plug access is good and plug wire routing is not difficult nor does it require heat shielding. They will fit on a '93-'97 f-body - a new y-pipe is mandatory.
Asking $450 + shipping from 22310. I've made multiple sales on this board, do a search if you like.
If you have questions, EMAIL ME at aa4d@erols.com as I will rarely look at this thread!
-Alex
Last edited by AlexA; Oct 23, 2003 at 10:32 AM.
Make me an offer guys (via email) Any y-pipe designed for Hooker headers will fit. Mufflex, Summit, and Thunder Racing are a few that make them.
These are great headers - I made serious improvements in power over my Hooker shorties and y-pipe.
-Alex
These are great headers - I made serious improvements in power over my Hooker shorties and y-pipe.
-Alex
Guys, my zip code is 22310. The package I will send it in is the same one my Jet Hots came it. It's 48x24x12 inches box and will probably weigh 35 lbs or so. You can all do the calcs to your zips with that info on the various shipping sites.
$450 + shipping is what I'm asking. If you pick it up, $420 (saves me the hassle).
-Alex
$450 + shipping is what I'm asking. If you pick it up, $420 (saves me the hassle).
-Alex
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
LT1 Based Engine Tech
2
Jan 5, 2015 07:14 PM



