Dynatech Splitflow 4" in/out muffler
07-13-2008, 03:01 PM
#1
Registered User
Thread Starter
Join Date: Jul 2007
Location: Pittsburgh
Posts: 353
Dynatech Splitflow 4" in/out muffler
Was abit too loud for me.
this was on my car for 20 miles and few startups while i was breaking in the motor. I went with a Ultraflo Round and its working for me
Muffler is like new but does have a scrape on it where i bottomed out a touch on a back road. not dented or anything. wasnt welded on either
inlet is 4" ID so slips on 4inch od piping. outlet is 4" od so need a slip joint to connect or weld straight to it. I have slip fitting i used too if you want for 5 bucks
asking 65 shipped, these sell for 105 new and are like the XR1 from borla. good flow, good strong sound but was loud for me.
this was on my car for 20 miles and few startups while i was breaking in the motor. I went with a Ultraflo Round and its working for me
Muffler is like new but does have a scrape on it where i bottomed out a touch on a back road. not dented or anything. wasnt welded on either
inlet is 4" ID so slips on 4inch od piping. outlet is 4" od so need a slip joint to connect or weld straight to it. I have slip fitting i used too if you want for 5 bucks
asking 65 shipped, these sell for 105 new and are like the XR1 from borla. good flow, good strong sound but was loud for me.
Thread
Thread Starter
Forum
Replies
Last Post
GusarskiSS
Exhaust System
1
09-02-2015 03:51 PM