First up: Ron Davis racing radiator. 31x19.5x 4" thick (see notecard for scale). Dual -12an inlets, 1.75" outlet. Dual pass radiator (inlet/outlet on same side, twice the cooling).

This is rated at over 1500hp cooling capacity. Comes with a 3/8" bung on the filler neck for a temp sensor, and an overflow fitting.

Looking for 275 plus shipping (over 600$ to make it)



Brand new Bosch LS1 water pump that has been modified to work with this radiator. The outlet was removed in order to weld on two -an bungs (ill include). Both the heater fitting were remove and tapped/plugged. Water pump has 0 miles on it, with a brand new l92 thermostat housing as well. Pump was 189, t-housing was 25 and bungs were another 40$. The bungs just need to be welded on and its good to go.



175 takes it!

420$ is you want the whole setup.


I am going to a remote Meziere pump and a thinner radiator due to space constraints (twin turbo in a foxbody).

 

Ttt...

 

Looks like it's built for a mack truck!!!


Free bump

 

Ttt>..

 

Ttt...