ok so i'm going to be buying a fogger kit for my sbc. is it worth trying to do all the drilling and bending and stuff on my own or just pay to have it done?

its a brodix hv1002 intake, going with sportsman kit most likely.

thanks

 

Depends on how much time you want to spend and if your good at tube bending.
I bought my LT1 intake already setup from a local guy who did all the work but after getting a close up look at it I think I could build one myself. It would take a while and I might make a few bad bends in the process but it does not look that tuff.
Nitro Dave can set up your manifold for it, not sure how much it would cost but it probably would save you some frustration.

 

sweet thanks