How do they expect you to do this? I have mine zip tied in, but it's kinda ugly. They have the 4 rivet holes in the corners but they're only like 1/8" I.D. Do they expect it to lay flat on something and be double-sided taped down? Or is there something I'm missing here? It WORKS how/where it's at, should I take that and be happy?

 

i have mine here and it is going in tonight im not sure where i will put it but when i do i will post a pic. and what is your on off. i am going 3000 5800 and we will c how that goes.

 

It's on at 3000 and off at 4200 because my car shifts at like 4500 when I'm WOT. Now that I put that into words it doesn't look like a very good window, kinda small...

 

i lost my directions for the digital 6 which wire is the tach wire for the window switch?

 

white

 

The white wire is the "signal input"

Link to directions: http://www.msdignition.com/pdf/8969_frm25515.pdf

 

i dont have a digial rpm switch, i just need to know what wire to connect my tach at the rpm switch to the digital six

 

Then try this link: http://www.msdignition.com/downld1.htm

 

is it the peg on the side that i connect to the tach wire on the rpm switch?