Has anyone heard of them? Where are they located? Phone #?

Thanks in advance,

Kevin

 

AFAIK they used to do the head porting for Modern Musclecar, the guys name is Ron Sharp. I have a set of their heads on my car right now and am not real happy with them.

 

Yup, the guys name is Ron Sharp, and i personally don't have any of his stuff, but he has done alot of stuff out there, even for the likes of GM, i heard he takes awhile to get in and out, but he works out of his garage, he has a whole shop setup in his garage, i've seen it, and it's every car guys garage, all the tools and machines you want, well then again we could never have enough tools and machines, but still, i've heard both good and bad about everybody out there, so just ask around and weigh the options. There are tons of head porters in the area, i prefer to use Al Messin at Rhino Racing heads in Clinton Twp or sterling heights i think, he's doing my heads, and all the heads for Bill at Mach Performance.

 

Thanks guys, I have a set of the MMC heads I'm trying to hunt down flow #'ss to these cnc heads.

Kevin

 

I also have a set of MMC's CNC heads and would like to know what the flow numbers are. I don't remember mike telling me them or me asking him.

 

I was told mine are supposed to flow 285 intake & 215 exhaust at 0.600". But I have no proof of that.

If you guys ever figure out how to get flow number from Ron, I would like to know.

 

You should be able to take them to any head porter that has a flow bench, and he will be able to get you the numbers, usually costs around 75/100 bucks.

 

I had his heads on my car and when I was at his house picking them up (14 and Harper), he wrote down the flow #'s.

264/185 @ .500
262/190 @ .600

Intake 2.000
Exhaust 1.560

I still have the sheet infront of me.

All in all, I was not happy with my engine rebuild (355, comp 224/230 cam and Advanced Airflow heads). After spending over 6 grand, I sold my 94' for 12.