Would this work?
Thread Starter
Registered User
Joined: Mar 2006
Posts: 102
From: McChord AFB, WA
Would this work?
cc503
pac springs(don't wanna risk comp with all the bad news out there)
1.6 pro mags
on stock heads/injectors. I won't have the money for heads for quite some time...but cams and supporting valvetrain mods are relatively cheap. So what could I expect from this setup and is it safe? Anything any of you would suggest for bang for the buck performance w/o heads....safely of course. Just spun a rod bearing not too long ago, really don't wanna do it again...or blow up anything else for that matter.
Car in sig, engine rebuilt approx 2500 miles ago.
pac springs(don't wanna risk comp with all the bad news out there)
1.6 pro mags
on stock heads/injectors. I won't have the money for heads for quite some time...but cams and supporting valvetrain mods are relatively cheap. So what could I expect from this setup and is it safe? Anything any of you would suggest for bang for the buck performance w/o heads....safely of course. Just spun a rod bearing not too long ago, really don't wanna do it again...or blow up anything else for that matter.
Car in sig, engine rebuilt approx 2500 miles ago.
Thread
Thread Starter
Forum
Replies
Last Post
squarehead
General 1967-2002 F-Body Tech
7
Jan 15, 2015 07:02 PM
