Who makes a good 355 kit? I want a crank and rods set that will handle 600 hp.
Registered User
Joined: Dec 1999
Posts: 1,697
From: Petersham, MA
Plenty of choices for this one. A good bet is to go with a Callies Dragonslayer forged crank, Callies forged rods, and JE pistons. I'm sure Nu-tek could put together a balanced rotating assembly for you.
Registered User
Joined: Oct 2000
Posts: 786
From: Charlotte, NC
If I were on a tight budget, I'd probably use the stock crank, some relatively cheap 4340 h-beams, and spend the $ on a nice piston from CP, Ross, JE, etc. Stud the mains 
.
If I had $600-650 more.. I'd have splayed mains..
If I had $ ontop of that, I'd probably pick up a 4130 crank...
.... more $..
Depends on your budget, but there's plenty of "kits" out there pieced together from Mfr's like Eagle, or distributors like Summit & flatlander racing
.If I had $600-650 more.. I'd have splayed mains..
If I had $ ontop of that, I'd probably pick up a 4130 crank...
.... more $..
Depends on your budget, but there's plenty of "kits" out there pieced together from Mfr's like Eagle, or distributors like Summit & flatlander racing
Thread
Thread Starter
Forum
Replies
Last Post
1LEThumper
Forced Induction
40
Jul 14, 2003 12:45 PM
