OK i am getting the cc306 cam and I already have a set of springs that I bought with the heads that I have. My question is will these springs be too much or will they be ok to use with the CC306. The spring spec's are as follows : They are dual vlave springs with a seat pressure of 135 @ 1.910; Open pressure of 320 @ 1.25 and coil bind at 1.150. I was told that this setup was good up to .650 lift but i just want to make sure that these springs aren't too much for the cc306 cam. Thanks

Stryker

 

Ok, is there no one here that is experienced enough to answer my question, or does it belong in the Advanced Tech forum ? I already did a search on this but I read for about 3 hours and found a couple fairly close answers but nothing right on the money. So how about it, can anyone tell me if these will be ok to use ?

Stryker