Removing Throttlebody shaft
Thread Starter
Registered User
Joined: Jul 1999
Posts: 3,647
From: Winnipeg, Manitoba, Canada
Removing Throttlebody shaft
I bought a 52mm TB and they sent me a 94+ TB instead of a 93.
Its a stock 94+ thats been ported out.
Can I simply swap throttlebody shafts from my 93 to make it work?
What's holding the shaft in place? Just the butterfly valves?
Its a stock 94+ thats been ported out.
Can I simply swap throttlebody shafts from my 93 to make it work?
What's holding the shaft in place? Just the butterfly valves?
Thread Starter
Registered User
Joined: Jul 1999
Posts: 3,647
From: Winnipeg, Manitoba, Canada
NM
Figured it out.
Grind the backs of the screws off the butterfly valves.
Grind the 4 stoppers holding the washer in place at the end of the shaft where the TPS goes.
Then hammer the bastard out.
Sorry just venting.
Figured it out.
Grind the backs of the screws off the butterfly valves.
Grind the 4 stoppers holding the washer in place at the end of the shaft where the TPS goes.
Then hammer the bastard out.
Sorry just venting.
Thread
Thread Starter
Forum
Replies
Last Post
Victor Lamb
Suspension, Chassis, and Brakes
3
Aug 26, 2017 02:52 PM
PFYC
Supporting Vendor Group Purchases and Sales
0
Apr 16, 2015 09:57 AM