Rear End install help
Thread Starter
Registered User
Joined: Oct 2002
Posts: 246
From: Lenexa, KS
Banned
Joined: May 2002
Posts: 1,475
Re: Rear End install help
Originally posted by 1995ta
http://mofbody.com/forums/viewtopic.php?t=4496
http://mofbody.com/forums/viewtopic.php?t=4496
Your supposed to pull the axles BACK AFTER you install the c-clips... So you push the axles all the way in, put the c-clip on and then pull on the axle as if you were going to pull it back out and VLOIA good to go 
Registered User
Joined: Mar 2002
Posts: 1,842
From: Bloomfield Hills MI
So loosened the nut holding the roll pin in, removed the pin and C clips to push the axles back in? Also you sure that posi is 28 spline and not 26?
Originally posted by 1995ta
We tried that, no luck.
We tried that, no luck.
Registered User
Joined: May 2001
Posts: 642
From: Wichita, Kansas
Pretty sure thats a torsen posi unit if it's out of a 2001, and it has this kinda of a rectangle shaped block that slides down in there and you put the retaining bolt in it, I assume you dont have that block that goes in the middle?
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM
