The rattle is comming from my Pace Setter Y-Pipe hitting the floorboard under the driverseat. The y-pipe is formed with an indentation where the little piece comes down about an inch from the chasis and back up. Y-pipe fits perfect but still rattles against the floorboard.


Any ideas on what to do to stop this from happening? It knocks hard enough to set of my LT-4 KM sometimes.

 

I had the same problem. I took some heat tape and rolled it up and wedged it between the floor and the y-pipe. I don't like the idea of doing that but it works.

Rob

 

I was thinking about something like that, I'll give it a try. Thanks.

 

yea mine does it too when i floor it, even after i took it off and re-shaped the indent on the y pipe 3 times. i took a piece of rubber heater hose and wedged it in there, but the tape idea is probably better

 

New motor mounts usually fix this problem.

 

yep. Replace the motormounts. Fixed it for me.