I need to know if anyone has any ideas as to what size pushrods im going to be needing with my new rebuild. I have dished pistons, trickflow twisted wedge 13/23 degree heads, 1.5 rockers, .060 over. Any suggestions or will i have to do the measurements once the motor is together??

 

measure.

 

ok thanks

 

May sound sarcastic, but he's right. Every single setup is different so you'll have to measure it yourself to find out for sure. I'd also venture to guess that you'd need two different sizes because of those heads. Are you using an LT1 or sbc?