Problems at start up
Problems at start up
The car runs fine after i start it up and get it running. It acts like a carbed car with choke issues on start up after it has been sitting for 30 min or so.
I just replaced the fuel pump because the stock one went out. I have a new Iac, Tps, Map, Starter Opti, Plugs and wires. When it does start it idels around 1500 till it settles down to the normal range
Any ideas on what to change next would be great.
Chris
I just replaced the fuel pump because the stock one went out. I have a new Iac, Tps, Map, Starter Opti, Plugs and wires. When it does start it idels around 1500 till it settles down to the normal range
Any ideas on what to change next would be great.
Chris
Re: Problems at start up
I was with Chris when him and another guy helping him got the fuel pump on. When the car starts, it sounds like it's cammed for a little bit until it starts idling at 1500ish, smooths out, then settles down again to around 900. Once it settles down like this, it runs normal. It doesn't blow out any black smoke from running rich, just runs rough like it has a pretty warm cam in it. It did this with the fuel pressure at 35lbs where it's at now and even when it was at 70lbs before he turned it back down with the regulator. Also, it's kind of hard starting when cold unless you turn the key on and wait a few seconds for fuel pressure to build, then it's fine. Just thought I'd clarify things.
Jason
Jason
Re: Problems at start up
the problem is that it dies when it starts because idle is low it feels like a carbed car with choke issues when you give it the gas to raise idle it doesnt want to rev until it warms up for a while then drives fine
Re: Problems at start up
somebody help me too. i've replaced the egr valve, ecm, spark plugs, wires (a year ago), battery, starter, fuel filter, trans has been rebuilt with slight mods, added cold air intake, ignition fuses and ignition coil. the car is getting fuel because i can get it started on rare occassions. i don't know if i need an ignition module, tps, or distributor. i need some help here guys.
Thread
Thread Starter
Forum
Replies
Last Post
Alex Barnes
LT1 Based Engine Tech
16
Jan 24, 2015 10:21 PM
Oncomingstorm22
General 1967-2002 F-Body Tech
4
Jan 22, 2015 07:15 PM



