My question is will the stock **** work on the pro5.0 shifter.

 

Should work with no problem, mine does.

 

Thanks

 

works fine with mine


oh yeah....wooo hooo 2000 posts!! Took long enough

 

So thats how you become a prominent member...Hmmmm

Only 1700 more posts to go.

 

I got that title way before the 2k mark but not sure when.

 

Well heres one more for the record books.

 

Yes it works fine. Even after i cut 1.5in's off the shifter stick. I didnt want to pay $40 for a Lou's short stick so i hack sawed an inch or so off. Works just as good and saved me $40

 

Are you trying to become a prominent member too?

Seriously, if you cut 1.5"off the stick, how much thread is left for the **** to screw into?

 

There's alot of thread on stick which gives you the opportunity to cut it back moreso than others.

 

Looks like your the one trying to be the prominent member with all your posts

I chopped an 1'' off mine. You could proubly take about 2'' off but that would be getting a little short for me. Then it becomes hard to shift because of the counsel and the boot

 

Well ofcourse I am. Didn't you read my responses. Normally I would not even respond to your commentary.
But in this case... anyway here is one more...One more closer to prominent member status. So do I get a t-shirt or something when I become a prominent member?

Oh, and thanks for the response it is appreciated

 

I didn't chop mine off. I was fine with the height that it is now

 

I wouldn't chop mine off either. I'm happy with the length...I meen height it is now...hang on...are we talkin about the same thing?