Hey everyone, I had a local shop install a new clutch on my Z and after driving it home the car now won't start. It's that feeling you get when you don't push the clutch pedal in far enough and then turn the key. Power, but absolutely no spark to start. Now since it's too late, is this anything that I can check in the morning? Did a connection not go in tight enough? Any insight here would be much appreciated!

 

its a long shot, but check the power to the starter... its an M6 so have you tried rolling it and popping the clutch to get it to start?

 

well, it ended up being the clutch safety switch. it was a biatch to get to under the dash but only took about 15 minutes to replace. now all is good!