Mods:
MTI CAI
Hooker LTs
Off Road Y
Open Borla
Vigi3200


267RWHP 302RWTQ <-turd But it was 92*F with no dyno tricks, stock tune

 

good numbers.

 

Very nice

Had you thought about an aluminum driveshaft and/or a mail order tune?
I think they would make nice additions to your mods list.

 

That converter is sucking up a lot of the power.

 

I don't think those are too bad, mailorder tune oughta tack on at least 10 rwhp I would think, pretty respectable for an auto, I'll be happy if I dyno that. Are those SAE or STD numbers, if they're not corrected at that temperature maybe they'll bump up a bit there too.

 

Car has a stock drive shaft and the stock 93 tune, think those are the corected numbers, I glanced at the sheet, maybe I'll scan it in.

 

Dang, started the run at 4000 RPM? The numbers aren't all that bad, but I'd like to see the numbers in the low RPM too. I try to start mine about 1800 RPM. You may have actually had higher TQ numbers, but it's hard to tell because the dyno started recording so high.

Dan

 

I agree with the convertor sucking up some power. My car dyno'd 330 rwhp...but then again it was flatlined on 10:1 on the wideband, pig rich.

 

One of the guys on tech posted his times, his is cam only running 108MPH in the 1/4, car made 297rwhp, so with a tune I may not be that far off.