just started cam install...
Thread Starter
Registered User
Joined: Nov 2003
Posts: 382
From: Baton Rouge, LA
just started cam install...
anyone have any last minute advise, im so excited i can barely stand it, i guess im just a loser though...
its a futral cam 235/241
schubeck lifters
pro mag 1.6 nsa 7/16
cloyes double roller
csi pump
chromeoly pushrods
k800 springs
titanium retainers
costing a bit more than i was expecting at first, but i decide that i wanted to go as good as i reasonably could (schubeck lifters, chromeoly pushrods, titanium retainers) all im waiting on is the timing chain, i sure hope its here by friday
its a futral cam 235/241
schubeck lifters
pro mag 1.6 nsa 7/16
cloyes double roller
csi pump
chromeoly pushrods
k800 springs
titanium retainers
costing a bit more than i was expecting at first, but i decide that i wanted to go as good as i reasonably could (schubeck lifters, chromeoly pushrods, titanium retainers) all im waiting on is the timing chain, i sure hope its here by friday
Registered User
Joined: Dec 2004
Posts: 542
From: Ballin' in Hotlanta
Re: just started cam install...
Good luck! Just make sure you keep everything very clean. I've been just about to do mine for 4 weeks now 
EDIT: Oh, be have you got all the little stuff yet? Gaskets, consumables?
EDIT: Oh, be have you got all the little stuff yet? Gaskets, consumables?
Last edited by Beyonce Knowles; Apr 9, 2005 at 07:06 PM.
Thread Starter
Registered User
Joined: Nov 2003
Posts: 382
From: Baton Rouge, LA
Re: just started cam install...
no im going to try to get them all tomorrow, i wont have the timing chain till later on this week, so im not in THAT big of a rush, though i do want it done for sat's car show
Thread
Thread Starter
Forum
Replies
Last Post
dbusch22
Forced Induction
6
Oct 31, 2016 11:09 AM