i pulled the iac because the car was idleing at 2grand. so i pluged it into another car and it moved in and out. but when i plug it into my car and turn the key on and off it will not move at all. i checked all the fuses and reset the computer but still no luck. any ideas?

 

check the wiring and the plugin?

 

this all started after i put a piece of cardboard over the throttle bodie to lower the idle, just to see where i wanted the idle set at. but it would not run worth a crap so i pulled the card board off. when i pulled the cardboard off it went back to idle. the next morning i started it and it would not idle down.

which wires should be getting voltage?

 

checked all wires from the pcm connector to the iac connector. they all checked out good.

 

ttt

 

heeeeeellllllllllllp! what voltages should the iac be geting?

 

could the computer be fu(ked up? the car runs but it still won't move.

 

I would check it with a scanner to see what it is commanding the IAC to do.

 

brian is sending me a pcm as we speak. if its not something with the pcm i don't know what it could be. does the iac work off a voltage pulse or what?

 

put the other pcm in and it works perfect.WTF

any ideas?

 

I guess you have a bad computer. Put the other back in and see if it still fails.