how tight to tighten valve covers?
Thread Starter
Banned
Joined: Jul 2001
Posts: 3,604
From: Milton, FL
how tight to tighten valve covers?
i replaced my gasket on my passenger side valve cover, how tight should bolt it down?
right now its down hand tight with a small cresent wrench, but not nearly as tight as i could get it if i used a bigger tool or put my back into it.
right now its down hand tight with a small cresent wrench, but not nearly as tight as i could get it if i used a bigger tool or put my back into it.
Registered User
Joined: Dec 2001
Posts: 1,519
From: High Orbit
If you don't have a tq wrench, just snug them down. You don't want to get gorilla with them because they'll just start caving in the valve cover/possibly messing up the gasket seal. Tighten the inner ones, then the outer ones, then go back and recheck the inner ones, etc. Check them again later as needed.
Thread
Thread Starter
Forum
Replies
Last Post
