Hi, I would like to know if is easy put
to my Lt1 the CSI Electric WP ???

I am from Puerto Rico and here the mechanic want
$ 340 for that labor ...

Help me if know >>>??? These is a hard work ???

 

pulling the water pump is a pita. Then you need to drive out the mechanical shaft. plug the hole. installing the pump in the housing is easy. You'll the need to notch the fan shroud for it to clear. Bolt it back up, refill the coolant and bleed the system. Wire it up with a fuse and 30amp relay.

1-10 maybe a 5?

 

yeah, you will probably need access to some sort of press, a plug and maybe a file or die grinder to notch the housing. I work at my schools machine shop so i turned the plug out of aluminum, pressed it in and ground the housing in maybe 2 hours.

 

Take a look at this link.

http://ken.lowrance.com/projects/CSI...mp/Default.htm

 

We found a sanding wheel on a dremel, oddly enough, was the perfect thing for making the notches on the water pump.

As for driving out the driveshaft.. that's a pain in the ***. I didn't have access to a press so I used my air impact hammer with a chisel bit.

 

Hey!

Thanks

Now I seen that not is easy install the water pump
I think I will pay the $ 340. for the mechanic do the job

Thanks !!!!!!!

 

hope he's gonna wire it for you

 

Impella(sp?) pops off easily with a prybar
Then hammer the shaft out.
Dremmel etc to cut the notches.
Done.

 

Save some money do it yourself, I did it when I was 18 with the instructions GetaZforgetGT posted.